154 Removing and replacing parts Q1860-90918
Tray 1 lift plate
1 Remove the top cover (see page 115), the front cover (page 120), the left and right side
covers (page 123), and the Tray 1 shaft (page 150).
2 Rotate the Tray 1 lift plate to the front of the printer, and then carefully pry down each hook
(callout 1) until the hook is released from the pivot pin.
Note When you remove the lift plate, be careful not to lose the spring (callout 2).
Figure 87. Tray 1 lift plate removal
2
2
2
1
www.GovTechMedia.com
To Next Page
Loading...
