Low-voltage power supply PCA
1. Remove the following components:
●
Right cover. See
Right cover on page 86.
●
Formatter. See
Formatter on page 76.
●
Face-up bin. See
Face-up bin on page 87.
●
Right lower cover. See
Right lower cover on page 97.
●
Top cover. See
Top cover on page 89.
●
DC controller cover. See
DC controller cover on page 100.
2. Use a flatblade screwdriver to release the connector cover (callout 1). Put the point of the
screwdriver at the indicated location (callout 2).
Figure 5-149 Removing the low-voltage power supply PCA (1 of 6)
ENWW Printed circuit assemblies (PCAs) 151
To Next Page
Loading...