HP LaserJet 5200 - Page 232

Control panel message Description Recommended action
Deleting... The printer is in the process of deleting a job. No action necessary.
Duplexer Error Remove Duplexer The duplexer has been removed.
Duplexing is not available for the HP LaserJet
5200L.
1. Turn the printer off.
2. Reinstall the duplexer.
3. Turn the printer on.
Duplexing...Do not grab paper During duplex printing, the paper emerges for
a short time before it is pulled back into the
printer.
Duplexing is not available for the HP LaserJet
5200L.
No action necessary.
EIO <X> Disk Not Functional
alternates with
<current status message>
The EIO disk in slot <X> is not working
correctly.
1.
Press
to see step-by-step
information.
2. Turn the printer off.
3. Remove the EIO disk from the indicated
slot and replace it with a new disk.
4.
Press
to exit.
EIO <X> Disk Spinning Up
alternates with
<current status message>
The EIO disk device in slot <X> is spinning up
its platter. The message appears for
approximately 15 seconds after the printer
exits PowerSave mode, and jobs that require
disk access will be delayed.
No action necessary.
Event Log Empty SHOW EVENT LOG was selected from the
control panel, and the event log is empty.
No action necessary.
External Accessory Not Supported
alternates with
<current status message>
Indicates that the external duplexer or 500-
sheet feeder is disabled because it does not
support the external accessory.
1.
Press
to see step-by-step
information.
2. Remove the duplexer or 500-sheet
feeder.
3.
Press
to exit.
Genuine HP supplies installed A new HP cartridge has been installed. The
printer returns to the Ready state after
approximately 10 seconds.
No action necessary.
GENUINE HP SUPPLIES DESIGNED FOR
<PROD>
alternates with
Ready
This genuine HP supply was not designed for
this printer and is not supported. The printer
can use it, but print quality might be affected.
Replace this supply with a genuine HP supply
that is designed for this printer.
Incorrect The PIN number is incorrect. Contact the network administrator.
INFLATE FAILURE An error has occurred during a firmware
upgrade.
Reinstall the firmware.
Initializing This message appears when the printer is
turned on.
No action necessary.
Initializing permanent storage This message appears when the printer is
turned on.
No action necessary.
212 Chapter 6 Troubleshooting ENWW