Control panel message Description Recommended action
Loading program X
alternates with
DO NOT POWER OFF
Programs and fonts can be stored on the
printer file system and are loaded into RAM
when the printer is turned on. The X specifies
the sequence number of the program being
loaded.
No action necessary.
MANUALLY FEED <TYPE> <SIZE>
alternates with
For help press
Tray 1 is empty and no other tray is available.
Load media into tray 1, and press to
continue.
Press
for help.
MANUALLY FEED <TYPE> <SIZE>
alternates with
To continue press
Media is in tray 1, but the print job requires a
specific type and size that is not currently
available.
Press to print from the tray.
or
Press
for help.
MANUALLY FEED <TYPE> <SIZE>
alternates with
To use another tray press
No media is in tray 1, and a print job requires
a specific type and size that is available in
another tray.
Press to print from another tray.
or
Press
for help.
MANUALLY FEED OUTPUT STACK
alternates with
Then press
to print second sides
The first side of a manual two-sided print job
has been printed and the printer is paused
until the output stack is reinserted.
1.
Press
to see step-by-step
information.
2. To print second side of the two-sided
print job, load the output stack into tray 1
with the printed-side down.
3.
Press
to continue.
MEM TEST FAILURE REPLACE DIMM 1 The memory DIMM has failed. Install a supported memory DIMM. See
Installing printer memory on page 30.
No job to cancel The Stop button was pressed but there is no
job or buffered data to cancel. The message
appears for approximately two seconds.
No action necessary.
No stored jobs There are no jobs to retrieve in the
RETRIEVE JOB menu.
No action necessary.
NON HP SUPPLY IN USE
alternates with
Ready
A non-HP supply is currently installed but
was pressed to override the message.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
NON HP SUPPLY INSTALLED
alternates with
For help press
A new, non-HP supply has been installed.
This message appears until an HP supply is
installed or you press
.
If you believe you purchased an HP supply,
go to
www.hp.com/go/anticounterfeit.
Service or repairs that are required as a result
of using non-HP supplies are not covered
under HP warranty.
To continue printing, press
.
214 Chapter 6 Troubleshooting ENWW
To Next Page
Loading...