HP LaserJet 5200 - Page 235

Control panel message Description Recommended action
ORDER CARTRIDGE LESS THAN XXXX
PAGES
alternates with
<current status message>
The CARTRIDGE LOW setting in the
SYSTEM SETUP submenu is set to
CONTINUE and low toner exits. When the
estimated pages reaches zero, the message
is replaced with REPLACE CARTRIDGE.
1.
Press
to see step-by-step
information.
2. Order HP part Q7516-67901.
3.
Press
to exit.
PAPER PATH JAM FRONT DOOR
alternates with
For help press
A page is jammed in the paper path. Open the front door and remove any jammed
media.
PAPER WRAPPED AROUND FUSER The paper has wrapped around the fuser.
This jam does not have a jam code.
1.
Press
to see step-by-step
information.
2. Turn off the printer.
3. If the printer has a duplexer, go to step 4.
If the printer does not have a duplexer,
go to step 6.
4. Slide the duplexer out halfway.
5. Open the rear door and remove the
duplexer.
6. Release the fuser NIP by slightly
pushing the rear door up and holding the
black plastic inside the rear door.
7. Slightly lift up the black plastic until it
releases from the rear door, and then
push the rear door toward the top of the
table.
8. Open the print-cartridge door and
remove the print cartridge.
9. Remove any jammed media.
10. Reinstall the print cartridge and then
close the cartridge door.
11. Reinstall the duplexer and close the rear
door.
12. Turn on the printer.
13.
Press
to exit.
Paused
alternates with
To return to Ready press the STOP key
The printer has paused. Press Stop to resume printing.
Performing upgrade A firmware upgrade is in process. No action necessary. (Do not turn off the
printer.)
Performing... PAPER PATH TEST The printer is performing a paper-path test. No action necessary.
Please Wait The printer is offline. No action necessary.
ENWW Control-panel messages 215