2. Remove the tray 3 retard roller (callout 1).
Figure 5-12 Removing the tray 3 retard roller (2 of 2)
3. Insert the new tray 3 retard roller.
Tray 3 pickup and feed rollers
1. Remove tray 3.
Figure 5-13 Removing the tray 3 pickup and feed rollers (1 of 2)
2. From the front of the printer, look up inside the printer to identify two rollers.
3. Remove the blue pickup roller by squeezing the left side of the roller tab (callout 1) and slide it to
the left to remove the pickup roller.
ENWW Customer self-repair parts 75
To Next Page
Loading...