Sleep Schedule
An IT administrator can use the Sleep Schedule screen to schedule product sleep schedules and wake
times on a daily basis. For example, the product can be set to wake up at 07:30, so the product has
finished initializing and calibrating and is ready to use by 08:00. The administrator sets only one wakeup
setting per day; however, each day can have a different wakeup setting. Additionally, to save energy,
the sleep delay can be set to turn the product off after a specific period of inactivity.
Figure 3-24 Sleep Schedule screen
1
3
4
2
Table 3-14 Sleep Schedule
Callout Area on the screen Information or capability that the area provides
1 HP EWS tabs and menus For more information, see Navigating through the HP Embedded Web Server
on page 4.
2 Wake Time Select one or more days on which to use the wakeup setting, and then set the time
the product is turned on each day.
3 Sleep Time Select one or more days on which to use the sleep setting, and then set the time
the product returns to Sleep Mode each day.
4 Sleep Delay Set the amount of time the product is idle before it goes into Sleep Mode. When the
product is in Sleep Mode, it uses less energy.
ENWW Sleep Schedule 63
To Next Page
Loading...
