4. Use the tray lifter sensor (SR9) test in the Tray/Bin manual sensor test to verify that the sensor is
properly functioning. If it is not, replace the lifter drive assembly.
5. If the error persists, replace the lifter drive assembly.
62.00.00 No system To continue turn off then on
Description
The product experienced an internal system failure.
Recommended action
1. Turn the product off and then on.
2. Reload the firmware.
3. Perform a firmware upgrade.
4. If the error persists, replace the hard disk.
69.11.YY Error To continue, touch “OK”
Description
This message displays to indicate an error during a duplex operation.
Recommended action
Turn the product off and then on.
70.00.00 Error To continue turn off then on
Description
The product experienced a DC controller failure.
Recommended action
1. Turn the product off and then on.
2. If the error persists, replace the DC controller.
81.WX.00 Wireless Network Error To continue turn off then on
Description
A wireless network component on the product has failed.
Recommended action
1. Turn the product off and then on.
2. Turn the product off, reseat the wireless network component, and then turn the product on.
3. If the error persists, replace the wireless network component.
220 Chapter 2 Solve problems ENWW
To Next Page
Loading...
