HP LaserJet M1319 - Multifunction Printer - Page 150

Main motor
1. Remove the following assemblies:
●
Scanner assembly. See
Scanner assembly on page 85.
●
Formatter. See
Formatter and fax card on page 122.
●
Left cover. See
Side covers on page 110.
●
Rear cover and fuser cover. See
Rear cover and fuser cover on page 113.
●
Print-cartridge door. See
Print-cartridge door on page 112.
●
Front cover. See
Front cover on page 115.
●
Scanner support-frame. See
Scanner support-frame on page 124.
●
ECU. See
Engine controller unit (ECU) on page 127.
●
Laser/scanner assembly. See
Laser/scanner assembly on page 131.
2. Disconnect the motor wire-harness connector (callout 1) and remove one screw (callout 2).
Figure 6-97 Removing the main motor (1 of 2)
1
2
132 Chapter 6 Removal and replacement ENWW