Secondary service menu
Use this menu to perform various tests and print out special reports.
Open the secondary service menu
1. Press the Setup button.
2. Simultaneously press and then release both the left arrow button and the OK button.
3. Press the OK button.
4. Use the arrow buttons to select the desired secondary-service option, and then press the OK
button.
5. Use the arrow buttons to select the desired submenu option, and then press OK .
6. After making the necessary menu item choices, wait for the product to enter the Ready state, and
then press Cancel to close the secondary service menu.
Menu item Submenu Description
Service Reports Cont. Self-Test The continuous self-test prints the configuration page
repeatedly until you press Cancel.
Cont. Copy Run a continuous copy test to test the copy function.
Error Report Print the error report to see firmware errors.
Display test Use the Display test menu to run a test of the control-panel
display lights and LCD screen.
Button test Use the Button test menu to run a test of the control-panel
buttons.
Show FW Version Use the Show FW Version menu to display the firmware
version number.
Cal Graphs Mono
Red
Green
Blue
NOTE: These submenus
include additional calibration
submenus.
Use the Cal Graphs sub-menus to calibrate the product
scanner.
File Sys Format Use the File Sys Format menu to reformat the fax file system
for fax storage.
CAUTION: All stored faxes and Phonebook entries are lost
when the fax file system is reformatted.
ENWW Service-mode functions 187
To Next Page
