Control panel message Description Recommended action
If the error persists, contact HP. See
www.hp.com/support/ljm1319 or the support
flyer that came in the product box.
No fax detected The product answered the incoming call but
did not detect that a fax machine was calling.
Allow the product to retry receiving the fax.
Try a different phone cord.
Plug the product phone cord into a jack for
another phone line.
If the error persists, contact HP. See
www.hp.com/support/ljm1319 or the support
flyer that came in the product box.
Fax memory is retained when there is a loss of power
The HP LaserJet M1319 MFP flash memory protects against data loss when a power failure occurs.
Other fax devices store fax pages in either normal RAM or short-term RAM. Normal RAM immediately
loses data when power is lost, while short-term RAM loses data about 60 minutes after a power failure
occurs. Flash memory can maintain its data for years without power applied.
Fax logs and reports
Use the following instructions to print fax logs and reports:
Print all fax reports
Use this procedure to print all of the following reports at one time:
●
Fax activity log
●
Phone book report
●
Configuration report
●
Block-fax list
1. On the control panel, press Setup.
2. Use the arrow buttons to select Reports, and then press OK.
3. Use the arrow buttons to select Fax Reports, and then press OK.
4. Use the arrow buttons to select All fax reports, and then press OK. The product exits the menu
settings and prints the reports.
Print individual fax reports
Use the control panel to print the following fax logs and reports:
●
Last call report: Provides information about the last fax sent from or received at the product.
●
Fax activity log: Provides a chronological history of the last 40 faxes that were received, sent, or
deleted, and any errors that occurred.
Table 7-5 Alert and warning messages (continued)
194 Chapter 7 Solve problems ENWW
To Next Page
