Restore the copy-settings defaults
Use the control panel to restore the copy settings to the factory-set default values.
1. On the product control panel, press Setup.
2. Use the arrow buttons to select Copy setup, and then press OK.
3. Use the arrow buttons to select Restore defaults, and then press OK.
Copy a book
1. Lift the lid and place the book on the flatbed scanner with the page that you want to copy at the
lower-right corner of the glass.
2. Gently close the lid.
3. Gently press down on the lid to press the book to the flatbed scanner surface.
CAUTION: Pressing on the flatbed cover with too much force can break the lid hinges.
4. Press Start Copy.
Copy photos
76 Chapter 8 Copy ENWW
To Next Page
Loading...
