Figure 6-13 Finish Up dialog
Click Quit to exit the installer.
Click Continue to return to the HP LaserJet Installer.
Printer setup
After installing the printing-system software in Macintosh operating systems, the device must be set up.
Topics:
●
Set up a printer with Mac OS X V10.4 or later)
●
Set up a printer with Mac OS X V10.3
●
Set up a printer with Mac OS X V10.2.8
●
Troubleshooting the printer setup
Set up a printer with Mac OS X V10.4 or later)
Carry out these steps after the software installation is complete.
1. If you are installing the device using a USB connection, connect the USB cable between the
HP LaserJet M5025/M5035 MFP and the computer. Turn on the device. If you are installing using
a network connection, verify that the network cable is connected to the device and the device is
on.
216 Chapter 6 Macintosh ENWW
Macintosh
To Next Page
Loading...
