4. Click Add (or the Set Up Printers... button in the Print & Fax screen, and then Add) to open the
add printer screen.
Figure 6-22 Add printer screen
5. Select the network connection protocol in the top pull-down menu. The two supported protocols
are Rendezvous and IP Printing.
NOTE Rendezvous is the easiest method and is the best method to use if the device is
installed on your local network.
IP Printing must be used if you are installing the device on a different network.
If you are using Rendezvous, carry out the following step:
Select the HP LaserJet M5025/M5035 MFP in the Name list. The Printer Model and Model
Name are selected automatically.
NOTE If you are on a network that has more than one HP LaserJet M5025/M5035 MFP,
print a configuration page and match the Rendezvous Printer Name to the name on the list
to identify the device you are installing. (See
Print the configuration page .)
NOTE If the HP LaserJet M5025/M5035 MFP does not appear in the list, verify that the
device is powered on and connected to the network. If it still does not appear, try turning the
device off and then on again. Finally, turn the computer off and then on again, then restart
the setup process. For more troubleshooting information, see
Troubleshooting the printer
setup.
ENWW Macintosh install and uninstall instructions 223
Macintosh
To Next Page
Loading...
