Figure 6-72 HP EWS – Authentication Manager screen
LDAP Authentication
NOTE The LDAP Authentication screen is not available for the HP LaserJet M5025 MFP.
Use the LDAP Authentication screen to configure a Lightweight Directory Access Protocol (LDAP)
server to authenticate device users. When LDAP authentication is selected as the Log In Method for
one or more Device Functions on the Authentication Manager page, the user at the device must enter
valid credentials (username and password) to gain access to those functions.
Authentication consists of two interdependent parts. First, the device verifies the user's credentials with
the LDAP server. After the device user has supplied valid credentials and has been authenticated, the
device searches for the user's e-mail address and name. If either step fails, the user is denied access
to the functions that have been configured to require LDAP authentication.
Use the LDAP Authentication screen to set up the parameters that are used to access the LDAP server
and searches for the user's information. Note that this page only applies when LDAP is selected as a
Log In Method on the Authentication Manager page. TheLDAP Authentication screen is shown in
the following figure.
ENWW HP Embedded Web Server (EWS) 269
Macintosh
To Next Page
Loading...
