2. Click Yes. The Cancel dialog box opens, stating that the setup was interrupted.
Figure 3-2 Cancel dialog box
3. Click Finish to close the installation screens.
Direct-connect installation through a USB port
The printing-system software should be installed before the HP LaserJet M5025/M5035 MFP is
connected to the computer through a USB connection and turned on. During the installation process,
the software generates a prompt to connect the device.
Unsupported operating system dialog box
The MS Windows NT 4.0 and MS Windows 98 operating systems do not support the
HP LaserJet M5025/M5035 MFP. When attempting to install the software in these environments, an
Unsupported Operating System dialog box appears.
An example of an Unsupported Operating System dialog box is shown in the following figure.
66 Chapter 3 Install MS Windows printing-system components ENWW
MS Windows install
To Next Page
Loading...
