When installing the HP LaserJet M5025/M5035 MFP over the network, click Wired Networking in
the Printer Connection dialog box.
For a network installation, connect the HP LaserJet M5025/M5035 MFP to the network and turn it on
before installing the printing-system software.
NOTE Wired networking refers to the print device being connected to the network by a network
cable. For wireless installation instructions using an HP Jetdirect ew2400 802.11g Wireless Print
Server or an HP Direct 380x802.11B wireless print server, consult the documentation that comes
with the print server.
Click Next to continue. The Searching dialog box opens, as shown in the following figure.
Figure 3-7 Searching dialog box
NOTE When installing the device over a network, allow the search for the first subnet in the
network to finish in order to find all available devices. After the first subnet is scanned for available
HP LaserJet M5025/M5035 MFP, the results appear in the Printers Found dialog box. However,
the installer continues to search the network for additional devices. The results of the first search
usually takes place within about 20 seconds. Subsequently, the search of the other subnets for
the full list of devices occurs. The results appear in the Printers Found dialog box (see
Figure
3-10 Printers Found dialog box).
NOTE If the device does not appear, the installation process includes the option of using the
TCP/IP address for the HP LaserJet M5025/M5035 MFP, which might be preferable to waiting
for the installer to finish the search.
If the network has a firewall that is blocking the installation, the Firewall Detected dialog box appears,
as shown in the following figure.
70 Chapter 3 Install MS Windows printing-system components ENWW
MS Windows install
To Next Page
Loading...
