Figure 3-14 Change TCP/IP Settings dialog box
If information in the IP Address:, Subnet Mask:, or Gateway: fields change (without clicking Next) and
then click Suggest Settings…, the fields refresh with information that was found by the installer and
reported in the Printer Found screen.
Type a different TCP/IP Address, Subnet Mask, or Gateway address and then click Next to open the
Confirm Network Settings dialog box (see
Figure 3-12 Confirm Network Settings dialog box).
If you clear the Use Default Port Name check box and click Next, the Set Port Name dialog box opens
(see
Figure 3-18 Set Port Name dialog box).
The Check Printer Connection dialog box, which appears when No, I want to install a different
printer is selected in the Printer Found dialog box or if the system failed to detect the device over the
network, is shown in the following figure.
76 Chapter 3 Install MS Windows printing-system components ENWW
MS Windows install
To Next Page
Loading...
