Document feeder whole unit (M575c model)
Before proceeding, remove the following assemblies:
●
Rear-upper cover. See the product repair manual.
●
Foam reflector kit. See the product repair manual.
Remove the document feeder
1. Remove four screws (callout 1), release three connectors (callout 2), disconnect one FFC
(callout 3), and then remove the document feeder cable cover (callout 4).
NOTE: Carefully thread the FFC through, and out of, the ferrite core.
Reinstallation tip When the document feeder is reinstalled, it might be easier to thread the
FFC through the ferrite core if you first remove the ferrite core from the holder.
Figure 1-191 Remove the document feeder assembly (M575c model; 1 of 2)
1
3
2
130 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...