6. Feed the wire harness and cable through the raceway (callout 1).
Figure 1-210 Transfer the control-panel cable (6 of 7)
1
7. With the wire harness and cable installed, make sure that the wire harness and cable are
completely installed and in the channel.
CAUTION: Do not pinch the wire-harness wires between the channel and the cable.
Figure 1-211 Transfer the control-panel cable (7 of 7)
Install foam reflector kit (white backing) on the new document feeder
▲
If a replacement document feeder, image scanner, or both assemblies are installed, you must
install a replacement foam reflector kit. See
Foam reflector kit on page 38.
ENWW
Removal and replacement procedures
145
To Next Page
Loading...