2. Disconnect five connectors (callout 1).
NOTE: Disconnect the larger connector on the right side from the bottom. Disconnect the two
smaller connectors on the right side from the top.
Figure 1-229 Remove the delivery fan, cartridge fan, and environmental sensor (2 of 9)
1
3. Release two tabs (callout 1), and then slide the delivery-fan and cartridge-fan assembly toward the
power-supply side of the product to release it.
Figure 1-230 Remove the delivery fan, cartridge fan, and environmental sensor (3 of 9)
1
ENWW
Removal and replacement procedures
159
To Next Page
Loading...