Tray-pickup drive assembly
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Formatter PCA. See
Formatter PCA on page 17.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left cover. See
Left cover on page 92.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Rear cover. See
Rear cover on page 98.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 148.
●
Low-voltage power supply (LVPS). See
Low-voltage power supply (LVPS) on page 153.
●
High-voltage power supply lower. See
High-voltage power supply lower on page 189.
Remove the tray-pickup drive assembly
NOTE: To remove the pickup motor only, see Pickup motor on page 194.
1. Remove one screw (callout 1), and then remove the sheet-metal bracket (callout 2).
Figure 1-285 Remove the tray-pickup drive assembly (1 of 10)
1
2
ENWW
Removal and replacement procedures
197
To Next Page
Loading...