2. Disconnect six connectors (callout 1; J106, J107, J108, J137, J138, J140).
NOTE: To locate DC controller connector locations, see DC controller PCA on page 8.
Figure 1-286 Remove the tray-pickup drive assembly (2 of 10)
3
3
3. Disconnect one connector (callout 1; J119), remove one screw (callout 2), and then release the
wire harness from the guides.
NOTE: To locate DC controller connector locations, see DC controller PCA on page 8.
Figure 1-287 Remove the tray-pickup drive assembly (3 of 10)
1
2
198 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...