6. Release one spring (callout 1).
CAUTION: The spring is not captive. Do not lose the spring when it is removed. Use a pair of
needle-nose pliers to safely retain the spring when it is removed. Do not use a flat blade
screwdriver to remove the spring; the spring could forcibly leave the product and strike you.
Reinstallation tip When you reinstall the spring, make sure that the laser/scanner fits tightly
up against the product chassis.
Figure 1-318 Remove the laser/scanner assembly (C/Bk) (6 of 7)
1
ENWW
Removal and replacement procedures
217
To Next Page
Loading...