10. When the assembly is correctly installed against the chassis, the pin above the swing gear
protrudes through the hole in the chassis.
Figure 1-350 Reinstall the main-drive assembly (10 of 11)
11. Install the main-drive assembly mounting screws, and then reinstall the developing-disengagement
motor (callout 1).
TIP: After reassembling the product, print a Color Band Test page.
If the test page shows one or more color planes are not printing (usually in the upper left corner of
the page), the cam or cams for the missing color plane are not correctly aligned. Repeat the
reinstall the main-drive assembly procedure.
Figure 1-351 Reinstall the main-drive assembly (11 of 11)
1
238 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...