Fuser-drive assembly
Before proceeding, remove the following components:
●
Toner-collection unit. See
Toner-collection unit on page 15.
●
Formatter PCA. See
Formatter PCA on page 17.
●
Fuser. See
Fuser on page 24.
●
Intermediate transfer belt (ITB). See
Intermediate transfer belt (ITB) on page 34.
●
Front-upper cover. See
Front-upper cover on page 83.
●
Stapler cover. See
Stapler cover on page 85.
●
Right-rear cover. See
Right-rear cover on page 90.
●
Left-upper cover. See
Left-upper cover on page 97.
●
Rear-upper cover. See
Rear-upper cover on page 95.
●
Left-upper cover. See
Left-upper cover on page 97.
●
Rear cover. See
Rear cover on page 98.
●
Front-top cover. See
Front-top cover on page 110.
●
Rear-top cover. See
Rear-top cover on page 112.
●
Document feeder whole unit. See
Document feeder whole unit on page 127.
◦
See
Document feeder whole unit on page 127.
◦
See
Document feeder whole unit (M575c model) on page 130.
●
Scanner-control board (SCB).
◦
See
Scanner-control board (SCB) on page 133.
◦
See
Scanner-control board (SCB; M575c) on page 136.
●
Image scanner whole unit. See
Image scanner whole unit on page 139.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 148.
●
DC controller. See
DC controller PCA and tray on page 150.
●
Low-voltage power supply (LVPS). See
Low-voltage power supply (LVPS) on page 153.
●
Secondary transfer assembly. See
Secondary transfer assembly on page 171.
●
Power-supply fan and fan duct. See
Power-supply fan and fan duct on page 181.
●
High-voltage power supply lower. See
High-voltage power supply lower on page 189.
ENWW
Removal and replacement procedures
239
To Next Page
Loading...