HP LASERJET M575 - Service Preparation Steps; Post-Service Procedures

Before performing service
●
Remove all media from the product.
●
Turn off the power using the power switch.
●
Unplug the power cable and interface cable or cables.
●
Place the product on an ESD workstation or mat, or use an ESD strap (if one is available). If an
ESD workstation, mat, or strap is not available, ground yourself by touching the sheet-metal
chassis
before touching an ESD-sensitive part.
●
Remove the toner cartridges. See
Toner cartridges on page 11.
●
Remove the tray or trays. See
Tray 2 and 3 on page 23.
After performing service
●
Plug in the power cable.
●
Reinstall the toner cartridges.
●
Reinstall the tray or trays.
●
If the optional paper feeder was installed, place the product on the feeder.
6 Chapter 1 Removal and replacement ENWW