Install a replacement hard drive
After installing a replacement hard drive, you must reload the firmware by performing a firmware
upgrade.
Reload the firmware
Update firmware
1. Copy the xxxxxxx.bdl file to a portable USB flash drive.
2. Turn the product on.
3. The HP logo displays on the product control panel. When an underscore displays below the HP
logo, touch the logo to open the Preboot menu.
4. Touch the down arrow
button to highlight Administrator, and then touch the OK button.
NOTE: You might be prompted to enter a password to access the Administrator menu. Type the
password, and then touch the OK button.
5. Touch the down arrow button to highlight Download, and then touch the OK button.
6. Insert the USB flash drive with the xxxxxxx.bdl file on it.
NOTE: If the error message No USB Thumbdrive Files Found displays on the control-panel
display, you might need to connect the storage device to the external USB connection on the
formatter or try using a different portable storage device.
7. Touch the down arrow button to highlight USB Thumbdrive, and then touch the OK button.
8. Touch the down arrow
button to highlight the xxxxxxx.bdl file, and then touch the OK button.
NOTE: The upgrade process can take up to 10 minutes to complete.
TIP: If there is more than one xxxxxxx.bdl file on the storage device, make sure that you
select the correct file for this product.
9. When the message Complete displays on the control-panel display, touch the back arrow
button 3 times.
10. When the message Continue displays on the control-panel display, touch the OK button. The
product will initialize.
11. When the upgrade process is complete, print a configuration page and verify that the upgrade
firmware version was installed.
22 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...