3. Hold the locking lever in the release position, and then slide the HDD toward the edge of the
formatter to remove it.
Reinstallation tip When the HDD is reinstalled, make sure that the HDD is fully seated and
that the locking lever snaps into the locked position.
Figure 1-19 Remove the HDD (2 of 3)
4. Separate the plastic side rails (callout 1) from the hard drive, and then slide (callout 2) the plastic
cover from the hard drive.
CAUTION: The plastic rails can be tight fitting. Remove carefully to avoid breaking.
Figure 1-20 Remove the HDD (3 of 3)
1 1
2
ENWW
Removal and replacement procedures
21
To Next Page
Loading...