Page skew
●
Make sure that the media is loaded correctly and the
media guides are not too tight or too loose against the
media stack. See
Load media for more information.
●
The input bin might be too full. See
Load media for more
information.
●
Check the media type and quality. See
Supported paper
and other media for more information.
Curl or wave
●
Check the media type and quality. Both high temperature
and humidity cause media to curl. See
Supported paper
and other media for more information.
●
The media might have been in the input tray too long.
Turn over the stack of media in the tray. Also, try rotating
the media 180° in the input tray.
●
Open the straight-through output door and try printing
straight through. See Straight-through output path for
more information.
●
The fuser temperature might be too high. In your printer
driver, make sure the appropriate media type is selected.
If the problem persists, select a media type that uses a
lower fuser temperature, such as transparencies or light
media.
Wrinkles or creases
●
Make sure that media is loaded properly. See
Load
media for more information.
●
Check the media type and quality. See
Supported paper
and other media for more information.
●
Open the straight-through output door and try printing
straight through. See Straight-through output path for
more information.
●
Turn over the stack of media in the tray. Also, try rotating
the media 180° in the input tray.
●
For envelopes, this can be caused by air pockets inside
the envelope. Remove the envelope, flatten the
envelope, and try printing again.
ENWW Improve print quality 95
Downloaded from ManualsPrinter.com Manuals