Pickup assembly
Before proceeding, remove the following components:
●
Separation pad. See
Separation pad on page 13.
●
Paper-delivery tray. See
Paper-delivery tray (output bin extension) on page 21.
●
Left cover. See
Left cover on page 22.
●
Right cover. See
Right cover on page 25.
●
Front cover. See
Front cover on page 28.
●
Scanner assembly. See
Scanner assembly on page 30.
●
Cartridge door. See
Cartridge door on page 33
●
Top cover. See
Top cover on page 36.
●
Rear cover. See
Rear cover on page 38.
●
Formatter PCA. See
Formatter PCA on page 68.
●
Fax PCA (HP LaserJet Professional M1210 MFP series only). See
Fax PCA on page 70.
Remove the pickup assembly
1. Disconnect one connector (callout 1), remove five screws ( callout 2), and then remove the sheet-
metal formatter stay (callout 3).
NOTE: One screw has a flat washer and lock washer. Make sure that this screw is correctly
positioned when the assembly is reinstalled.
Figure 1-123 Remove the pickup assembly (1 of 6)
2
1
3
84 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...