5. Rotate the back of the cover away from the product and down.
TIP: It might be easier to remove the cover, if you let the left side of the product protrude off of
the work surface to give the cover enough clearance to swing down past the bottom of the product.
Figure 1-31 Remove the left cover (5 of 6)
6. Continue to rotate the cover down and away from the product, until the tab (callout 1) located under
the control-panel assembly is released.
Figure 1-32 Remove the left cover (6 of 6)
1
24 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...