4. Disconnect one connector (callout 1) and carefully set the PCA out of the way.
CAUTION: The motor driver PCA is still connected to the product by the FFC.
Figure 1-109 Remove the main motor (4 of 7)
1
5. Release the wire harness (callout 1) from the guide (callout 2), remove one screw (callout 3), and
then remove the cover (callout 4).
Figure 1-110 Remove the main motor (5 of 7)
3
4
2
1
76 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...