3. Press the OK button to start the calibration process.
A Calibrating message will display on the printer control panel. The calibration process takes a few
minutes to complete. Do not turn the printer off until the calibration process has finished.
4. Wait while the printer calibrates, and then try printing again.
Touchscreen control panels
1.
On the printer control panel, touch the Setup
button.
2. Open the following menus:
●
System Setup
●
Print Quality
●
Color Calibration
3. Touch Calibrate Now. A Calibrating message will display on the printer control panel. The calibration
process takes a few minutes to complete. Do not turn the printer off until the calibration process has
finished.
4. Wait while the printer calibrates, and then try printing again.
Check the EconoMode settings
HP does not recommend the full-time use of EconoMode. If EconoMode is used full-time, the toner supply
might outlast the mechanical parts in the toner cartridge. If print quality begins to degrade and is no longer
acceptable, consider replacing the toner cartridge.
NOTE: This feature is available with the PCL 6 print driver for Windows. If you are not using that driver, you
can enable the feature by using the HP Embedded Web Server.
Follow these steps if the entire page is too dark or too light.
1. From the software program, select the Print option.
2. Select the printer, and then click the Properties or Preferences button.
3. Click the Paper/Quality tab, and locate the Print Quality area.
4. If the entire page is too dark, use these settings:
●
Select the 600 dpi option.
●
Select the EconoMode check box to enable it.
If the entire page is too light, use these settings:
ENWW Improve print quality 111
To Next Page
Loading...