11. Grasp the optic assembly by the sides and carefully remove it from the scanner bed and place it
on the scanner chassis.
CAUTION Do not touch the lens, mirrors, lamp, or components underneath the assembly
when handling the optic assembly.
The sheet-metal edges of the scanner chassis are sharp and can damage the optic
assembly FFC.
Figure 5-104 Remove the scanner optic assembly (9 of 13)
12. Before you proceed, note where the optic drive belt tension clip is positioned on the belt in relation
to the plastic FFC retainer (remember, the optic assembly was previously centered in the scanner
bed).
If the belt tension clip is not correctly positioned when the optic is reinstalled, it will interfere with
the belt drive pulleys when the optic moves.
Figure 5-105 Remove the scanner optic assembly (10 of 13)
244 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...