13. Grasp the left end of the scanner drive belt and carefully rotate the belt toward the left while you
slip the belt over and off of the pulley.
Figure 5-106 Remove the scanner optic assembly (11 of 13)
14. Release two tabs on the FFC retainer. Carefully pass the FFC through the opening in the scanner
chassis (behind the PCA) into the scanner bed.
Tip It might be easier to pass the FFC into the scanner bed if you remove the scanner
PCA.
Figure 5-107 Remove the scanner optic assembly (12 of 13)
ENWW Scanner 245
To Next Page
Loading...