15. Carefully remove the FFC and retainer from the scanner bed. Remove the scanner optic assembly.
Figure 5-108 Remove the scanner optic assembly (13 of 13)
To reinstall the drive belt and optic assembly
1. Make sure that the drive belt tension clip is correctly installed on the belt. The belt teeth must go
over the barrel of the clip, and the two clip ends (callout 3) should hook over the edges of the drive
belt.
Figure 5-109 Reinstall the optic drive belt (1 of 5)
246 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...