Rear inner cover
1. Remove the following components or assemblies:
●
Stapler rear cover. See
Rear cover on page 258.
●
Stapler right rear cover. See
Right and left rear covers on page 264.
●
Stapler output bin. See
Output bin on page 260.
●
Stapler output bin stay (support arm). See
Output bin stay (support arm) on page 270.
2. Remove one screw (callout 1) and slide the rear inner cover forward, out, and then away from the
stapler to remove it.
CAUTION Be careful not to damage the jogger guides or the flags on the flaps when you
remove or install the rear inner cover.
Carefully move the flap out of the way when the cover is reinstalled.
Tip To reinstall this cover you must remove the stack cover. See Stack cover
on page 272.
1
Figure 5-148 Remove the stapler rear inner cover
ENWW Stapler/stacker (HP LaserJet M5035xs only) 271
To Next Page
Loading...