Stack cover
1. Remove the following components or assemblies:
●
Stapler rear cover. See
Rear cover on page 258.
●
Stapler right rear cover. See
Right and left rear covers on page 264.
●
Stapler front door and stapler unit cover. See
Front door and stapler unit cover
on page 266.
●
Stapler output bin. See
Output bin on page 260.
●
Stapler output bin stay (support arm). See
Output bin stay (support arm) on page 270.
●
Stapler rear inner cover. See
Rear inner cover on page 271.
2. Release two tabs (callout 1) and slide the stack cover forward, out, and then away from the device
to remove it.
CAUTION Be careful not to damage the jogger guides (callout 2) or the flags on the flaps
(callout 3) when you remove or install the stack cover.
The stapler/stacker sheet-metal chassis has sharp edges. Be careful when you remove this
cover.
NOTE It might be easier to reinstall the stack cover if the jogger guides are repositioned
to allow the flaps to be lifted. To move the jogger guides, grasp the rear most guide and
gently pull it toward the front of the stapler assembly. Do not attempt to move the guides
using the front most guide.
See
Figure 5-160 Remove the stapler alignment and jogger guide assembly (5 of 6)
on page 279 for information about moving the guides.
1
2
3
Figure 5-149 Remove the stapler stack cover
272 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...