Paper feed assembly (stapler)
1. Remove the following components or assemblies:
●
Optional: ADF. See
ADF assembly on page 204.
●
Optional: scanner. See
Scanner assembly on page 232.
●
Stapler rear cover. See
Rear cover on page 258.
●
Stapler left door. See
Left door on page 259.
●
Stapler left cover. See
Left cover on page 262.
●
Stapler left rear cover. See
Right and left rear covers on page 264.
●
Stapler front door and stapler unit cover. See
Front door and stapler unit cover
on page 266.
●
Stapler unit. See
Stapler unit on page 273.
2. Disconnect one connector (callout 1; J2104) from the stapler PCA and pass the wire harness
through the hole in the stapler chassis (callout 2).
Figure 5-153 Remove the stapler paper feed assembly (1 of 3)
ENWW Stapler/stacker (HP LaserJet M5035xs only) 275
To Next Page
Loading...