●
Stapler left cover. See
Left cover on page 262.
●
Stapler left and right rear covers. See
Right and left rear covers on page 264.
●
Stapler front door and stapler unit cover. See
Front door and stapler unit cover
on page 266.
●
Stapler unit. See
Stapler unit on page 273.
●
Stapler output bin. See
Output bin on page 260.
●
Stapler output bin stay. See
Output bin stay (support arm) on page 270.
●
Stapler rear inner cover. See
Rear inner cover on page 271.
●
Stapler stack cover. See
Stack cover on page 272.
●
Stapler paper feed unit. See
Paper feed assembly (stapler) on page 275.
2. Disconnect six connectors (callout 1; J2106, J2107, J2108, J2109, J2110, J2111) and release the
wire harnesses from the retainer.
1
Figure 5-156 Remove the stapler alignment and jogger guide assembly (1 of 6)
ENWW Stapler/stacker (HP LaserJet M5035xs only) 277
To Next Page
Loading...