5. Pull the wire harnesses through the opening in the stapler chassis and release the harnesses from
the retainer (callout 5). Release one tab (callout 6) on the retainer.
NOTE The retainer will be removed as a part of the alignment unit.
5
6
Figure 5-159 Remove the stapler alignment and jogger guide assembly (4 of 6)
6. Grasp the rear jogger guide and move it approximately 25.4 mm (1.0 inch) toward the front of the
device (this moves both of the guides closer together and allows clearance between the rear guide
and the stapler chassis).
CAUTION Do not use the front jogger guide to move the jogger guides.
Figure 5-160 Remove the stapler alignment and jogger guide assembly (5 of 6)
ENWW Stapler/stacker (HP LaserJet M5035xs only) 279
To Next Page
Loading...