Jogger guide unit
1. Remove the following components or assemblies:
●
Stapler rear cover. See
Rear cover on page 258.
●
Stapler left door. See
Left door on page 259.
●
Stapler left cover. See
Left cover on page 262.
●
Stapler left and right rear covers. See
Right and left rear covers on page 264.
●
Stapler front door and stapler unit cover. See
Front door and stapler unit cover
on page 266.
●
Stapler unit. See
Stapler unit on page 273.
●
Stapler output bin. See
Output bin on page 260.
●
Stapler output bin stay. See
Output bin stay (support arm) on page 270.
●
Stapler rear inner cover. See
Rear inner cover on page 271.
●
Stapler stack cover. See
Stack cover on page 272.
●
Stapler paper feed unit. See
Paper feed assembly (stapler) on page 275.
●
Stapler alignment and jogger guide assembly. See
Alignment and jogger guide assembly
on page 276.
2. Release the jogger guide unit wire harness (callout 1) from the retainer (callout 2).
Figure 5-167 Remove the jogger guide unit (1 of 3)
ENWW Stapler/stacker (HP LaserJet M5035xs only) 283
To Next Page
Loading...