4. After the alignment and jogger guide assembly is reinstalled in the stapler chassis, make sure that
the two tabs (callout 3) at the end of the assembly towards the front of the device are seated in the
holes in the stapler chassis.
3
Figure 5-165 Install the stapler alignment and jogger guide assembly (4 of 5)
5. Clip the wire harness to the stapler chassis. Install the three mounting screws and two springs.
Pass the wire harness through the opening in the chassis. Connect six connectors to the stapler
PCA (J2106, J2107, J2108, J2109, J2110, J2111).
6. Grasp the rear jogger guide and move it outward (the guides should be aligned with the end of the
jogger plate).
CAUTION Do not use the front jogger guide to move the jogger guides.
Figure 5-166 Install the stapler alignment and jogger guide assembly (5 of 5)
282 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...