2. When you reinstall the alignment and jogger guide assembly, make sure that the flange on the unit
is inserted in the slot in the stapler chassis . Then slide the assembly back into the stapler chassis.
Figure 5-163 Install the stapler alignment and jogger guide assembly (2 of 5)
3. As you slide the alignment and jogger guide assembly into the stapler chassis, make sure that the
assembly (callout 1) rests on top of the stapler chassis (callout 2).
NOTE The figure below shows the scanner removed for clarity. Look under the scanner
at the stapler chassis to make sure that the assembly is correctly positioned on the chassis.
1
2
Figure 5-164 Install the stapler alignment and jogger guide assembly (3 of 5)
ENWW Stapler/stacker (HP LaserJet M5035xs only) 281
To Next Page
Loading...