5. When you reinstall the jogger guide unit, make sure that the wire harness is placed over the arm
of the alignment unit chassis.
Figure 5-170 Install the jogger guide unit (1 of 2)
6. After installing the jogger guide unit, grasp the rear jogger guide and move it outward (the guides
should be aligned with the end of the jogger plate).
CAUTION Do not use the front jogger guide to move the jogger guides.
Figure 5-171 Install the jogger guide unit (2 of 2)
ENWW Stapler/stacker (HP LaserJet M5035xs only) 285
To Next Page
Loading...