Front door interlock switch
1. Remove the following components or assemblies:
●
Stapler rear cover. See
Rear cover on page 258.
●
Stapler left door. See
Left door on page 259.
●
Stapler left cover. See
Left cover on page 262.
●
Stapler left and right rear covers. See
Right and left rear covers on page 264.
●
Stapler front door and stapler unit cover. See
Front door and stapler unit cover
on page 266.
●
Stapler output bin. See
Output bin on page 260.
●
Stapler output bin stay. See
Output bin stay (support arm) on page 270.
●
Stapler rear inner cover. See
Rear inner cover on page 271.
●
Stapler stack cover. See
Stack cover on page 272.
●
Stapler paper feed unit. See
Paper feed assembly (stapler) on page 275.
●
Stapler alignment unit. See
Alignment and jogger guide assembly on page 276.
2. Disconnect two connectors (callout 1) and remove one screw (callout 2).
Figure 5-172 Remove the front door interlock switch (1 of 3)
3. Release the wire harnesses from the retainer and remove the retainer.
286 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...