3. Note the location of two locator pins (callout 1) and one slotted tab (callout 2) on the paper feed
assembly.
1
2
Figure 5-241 Reinstall the paper feed assembly (3 of 8)
4. When the paper feed assembly is reinstalled, the two locator pins must fit in the holes (callout 3)
in the high-voltage power supply chassis.
The slotted tab on the paper feed assembly must be positioned over the pin (callout 4) on the MFP
chassis (below the drum ground). See
Figure 5-240 Reinstall the paper feed assembly (2 of 8)
on page 334 to locate this pin.
3
4
Figure 5-242 Reinstall the paper feed assembly (4 of 8)
ENWW Print engine (base unit) 335
To Next Page
Loading...