5. Reach inside the device and carefully raise the shutter (callout 5).
The assembly has two additional locator pins near the locking tabs that must be fully seated in the
holes (callout 6) in the MFP chassis when the assembly is correctly installed.
5
6
Figure 5-243 Reinstall the paper feed assembly (5 of 8)
6. Position the corner of the paper feed assembly with the slotted tab down into the cavity to engage
the pin. See callout 2 in
Figure 5-241 Reinstall the paper feed assembly (3 of 8) on page 335 to
locate the pin.
Make sure that the four locator pins on the assembly fit into the holes in the high-voltage power
supply and MFP chassis. Push down on the locking tabs to firmly seat them when the assembly is
installed.
Tip Use your fingers to hold open the shutter as you install the assembly. See callout 5
in
Figure 5-243 Reinstall the paper feed assembly (5 of 8) on page 336 to locate the shutter.
Figure 5-244 Reinstall the paper feed assembly (6 of 8)
336 Chapter 5 Removal and replacement ENWW
To Next Page
Loading...