3. Disconnect one connector (callout 2) and release one wire harness (callout 3) from the retainers
(callout 4).
4
2
3
Figure 5-250 Remove the laser/scanner (2 of 3)
4. Remove four screws (callout 5) and remove the laser/scanner.
NOTE If the optional assemblies were not removed in step one, you will need a short-shaft
(38 mm [1.5 inches]) screwdriver to remove the screws.
5
Figure 5-251 Remove the laser/scanner (3 of 3)
ENWW Print engine (base unit) 341
To Next Page
Loading...